1.4.0 Release Candidate 2

[Snoopy8]

Remove true type font and no need for additional input during install. I think you were planning to do this a while ago but it was going to be a big change?

What do you mean by this?

During the install process, there are 2 pop ups (pink buttons). These are for true type fonts. I recall you mentioning that you will take them out in the future? It would make the install cleaner if the pop ups were removed. This is a nice to have.
 

• Network Tab.  Showing Wlan0 DHCP, when it is disabled.  Eth0 enabled with proper ip address but display not showing DHCP.  Cannot change.
  

This is normal. You can't change ethernet settings from the network tab yet. Hopefully will address this in the future.

The Pi5 display is wrong. Eth0 is enabled, Wlan0 disabled. Yet on right side Wlan0 is set to DHCP
 

• Still requiring manual upload of NFS folders after reboot.  Tried changing service to "Requires", which resulted in long boot time but did not fix problem.
  

Can you show me a screencap of your NFS configuration? This is really unusual and shouldn't be happening.

2 nfs4 folders manually mounted.  Have tried mounting them as nfs3 folders.  Same problem, need to mount them manually on rebooting.


Synology DSM NFS setup screen.  Max NFS protocol can be NFS3, NFS4 or NFS4.1

 
NFS permissions for each Ip address (blanked out on screenshot). Have even tried "allow connections from non-privileged port.

Note that Synology does not allow SSH access, login to Linux.


Have also tried mounting SMB (CIFS) folders within SnakeOil.  Same problem of having to manually mount them on rebooting.

---
Created /media/snakeoil_cache, can now download LMS9 and NAA. Will check others later.