Raspberry Pi 3B+ : Support for Allo DigiOne (Signature)

[bernardhung]

Ah... yes I was going from memory there....no I2S to activate in raspi-config you are correct.
Have you entered allo-digione as the Name in Alsa Configuration in the Music Player tab of the Snakeoil web interface and rebooted ?

Can you post the full content of /boot/config.txt

Currently my kernel line in /boot/config.txt shows..

Code:

kernel=kernel-4.14.66-rt40-pi-snakeoil

Here you go, thanks in advance !

Code:

 
# For more options and information see
# http://rpf.io/configtxt
# Some settings may impact device functionality. See link above for details
kernel=kernel-4.14.66-rt40-pi-snakeoil
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720

# uncomment if hdmi display is not detected and composite is being output
#hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800

# Uncomment some or all of these to enable the optional hardware interfaces
dtparam=i2c_arm=on
dtparam=i2s=on
#dtparam=spi=on
# Uncomment this to enable the lirc-rpi module
#dtoverlay=lirc-rpi

# Additional overlays and parameters are documented /boot/overlays/README

# Enable audio (loads snd_bcm2835)
dtparam=audio=off
#enable_uart=1
dtoverlay=allo-digione

start_x=0