[SOLVED] Archive checksum error on installer 1.2.6

[agent_kith]

Just installed on another nuc successfully just days ago. Now when I install it shows



I tried on another nuc and then with another drive. Same issue. redownloaded, same issue. updated same issue

This is with Ubuntu 22.04.2 LTS. nucs are nuc7i7 and nuc10i3.

Can you run this command where the installer file is:
 

Code:

sha1sum snakeoil-installer-x86_64-1.2.6.sh

And confirm you get the following output:

Code:

c0d0ab9b8d64e3f6a0d495f974679b511b87ca0c  snakeoil-installer-x86_64-1.2.6.sh

And also this:

Code:

ls -l snakeoil-installer-x86_64-1.2.6.sh

You should see this something like so:
 

Code:

119907996 Jul 15 07:07 snakeoil-installer-x86_64-1.2.6.sh

If:

• the file size (119907996) don't match, your download is incomplete and you'll need to re-download the file.
  
• the file size is correct, but the checksum (c0d0ab9b8d64e3f6a0d495f974679b511b87ca0c) is different, then the download is incomplete.
  

In the two cases above you have to bypass any caching software (proxy) you or your ISP have.

Now if both numbers are correct, and you run the installer and still get the same error as your screenshot, then it's likely to be bad RAM (or other problem hardware). If it's bad ram or other hardware your system will usually be unstable under load (either freezing or rebooting).  To be honest I don't think this will be the case as I havn't experience bad hardware for a long time now (even on second hand gear). A good test is to re-run the installer and compare the string of numbers in your screenshot, if they are always different when you run the installer, then it's a hardware issue.