Latency from Cyclic Test in NUC

[hkphantomgtr]

My computer is an aluminum box with an internal SSD, there is also an external HDD connected via a USB port. Intel Celeron N3050 Processor. RAM DDR3 4Gb.

Thanks for your info, Valery!

---

 

Thanks a lot for your reply, koko6969koki.  Would you please kindly use this command to run the cyclic test again to display in us (10^-6, = millisecond / 1000) ? 

No problem!

I'm not a Linux expert, so I just found some cyclictest commands example online.
Can you tell me the full cyclictest commands expression that you wish me to perform? Everything from "sudo" to the end.

koko6969koki, Thanks again, and I'm sorry that I've forgotten to paste the command.  Here you are.

cyclictest -t4 -p 80 -N -n -i 10000 -l 10000 -q

Then it looks stop responding for about 1 minute.  It's normal and then it will show u the result.  If you need to break it, just press Ctrl-C.  

I'm really appreciate your info.  Nuc looks promising.  BTW, are you running your NUC in fanless chassis or just with the orginal chassis (got a fan inside)?